AudioRoundTable.com: Pi Speakers » How to fasten R11/13?

Home » Sponsored » Pi Speakers » How to fasten R11/13?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

How to fasten R11/13? [message #91969]

Thu, 28 May 2020 20:39

blvdre
Messages: 35
Registered: April 2010
Location: Burlington, VT

Baron

Getting closer to completing my 4pis, and have a roll of unfaced R11 on the way. I searched, but was unable to find information regarding a good method for fastening the insulation in place. Maybe because it's so obvious, no one's needed to ask Smile

Any help is greatly appreciated.

Report message to a moderator

Re: How to fasten R11/13? [message #91981 is a reply to message #91969]

Fri, 29 May 2020 15:30

Wayne Parham
Messages: 18792
Registered: January 2001

Illuminati (33rd Degree)

Remove the paper vapor barrier and glue the sheets in place with white glue. Just run a bead on the insulation and press it into place.

Report message to a moderator

Re: How to fasten R11/13? [message #91986 is a reply to message #91981]

Fri, 29 May 2020 16:03

blvdre
Messages: 35
Registered: April 2010
Location: Burlington, VT

Baron

Thanks, Wayne. And I got lucky; I found a source for fiberglass R11, unfaced, so no messing around removing the paper. Hopefully the binder and recycled content aren't an issue (functionally speaking).

R11 @ Menards

Report message to a moderator