AudioRoundTable.com: Pi Speakers » Just finished 4pi build need some tips

Home » Sponsored » Pi Speakers » Just finished 4pi build need some tips

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Just finished 4pi build need some tips [message #90756 is a reply to message #90755]

Fri, 09 August 2019 09:26

Wayne Parham
Messages: 18789
Registered: January 2001

Illuminati (33rd Degree)

The Zobel resistor connects on the crossover in position R3. There are two lugs nearest the corner, furthest away from the bank of R1/R2 resistors. Polarity isn't important. You can find the location of R3 on the board layout in the plans. I'll resend the plans if you've lost them.

Report message to a moderator

[Message index]

		Just finished 4pi build need some tips By: Jelly_bean on Thu, 01 August 2019 23:03
		Re: Just finished 4pi build need some tips By: Wayne Parham on Fri, 02 August 2019 11:11
		Re: Just finished 4pi build need some tips By: Jelly_bean on Sat, 03 August 2019 22:59
		Re: Just finished 4pi build need some tips By: OutOfSpace on Sun, 04 August 2019 17:08
		Re: Just finished 4pi build need some tips By: Wayne Parham on Mon, 05 August 2019 09:12
		Re: Just finished 4pi build need some tips By: Jelly_bean on Fri, 09 August 2019 00:32
		Re: Just finished 4pi build need some tips By: Wayne Parham on Fri, 09 August 2019 09:26
		Re: Just finished 4pi build need some tips By: Jelly_bean on Sat, 12 October 2019 23:47
		Re: Just finished 4pi build need some tips By: Wayne Parham on Mon, 14 October 2019 10:13

Previous Topic:	8 Pi Plans
Next Topic:	MiniDSP

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 04:39:21 CST 2024