AudioRoundTable.com: Craftsmen » Changing The LED colors

Home » Audio » Craftsmen » Changing The LED colors

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Changing The LED colors [message #87413]

Thu, 08 March 2018 23:57

Silver
Messages: 116
Registered: December 2013

Viscount

How hard would that be? For instance, a car radio. You buy one that has red LED lights, but you prefer green. Is it even possible to change them?

Report message to a moderator

Re: Changing The LED colors [message #87415 is a reply to message #87413]

Fri, 09 March 2018 08:01

gofar99
Messages: 1951
Registered: May 2010
Location: Southern Arizona

Illuminati (5th Degree)

Hi, You can change them only by replacing them. In some gear that would be easy. In a car radio a nightmare. Size and ease of getting to them is the issue. Most LEDs used for this application use about the same amount of current (1-10 milliamperes) but do vary in the voltage need. Some as low as 1.4 volts and other colors as high as around 3.5 volts. The various colors are related to the materials used in the LED and are specific to the voltage needed. In something like a car radio they could well be surface mounted on a board and not something even I would mess with. In a piece of consumer gear like an amplifier they are likely to be more typical ones with leads. These could be changed if you have decent soldering skill.

Good Listening
Bruce

Report message to a moderator