Home » Sponsored » Pi Speakers » Rs loading (resistor)
Rs loading [message #85364] Tue, 06 June 2017 16:52 Go to previous message
mellotron is currently offline  mellotron
Messages: 5
Registered: May 2017
Location: Ontario, Canada
Esquire
Hi,

I'm sourcing parts for a 4pi build and was wondering about the value for the Rs resistor rated at 16 ohms for the B&C 250. There weren't any 16 ohm available. I was just wondering if it would be ok to use something a bit higher (18ohm) or lower (12ohm) in this position. Thanks for any assistance.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Previous Topic: Pi 4 vs JBL 4430? Wayne?
Next Topic: Mid horn driver options
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Dec 17 20:22:29 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest