Home » Sponsored » Pi Speakers » 4 Pi Build Progress
Re: 4 Pi Build Progress [message #81465 is a reply to message #81462] Mon, 20 July 2015 12:10 Go to previous messageGo to previous message
BobTahoe is currently offline  BobTahoe
Messages: 32
Registered: July 2015
Location: Lake Tahoe , NV
Baron
Made some more progress yesterday after going to homedepot to pick up the rest of the MDF. Sadly their panel cutter wasn't working so i ending up having to get 14 2ft x 4ft MDF boards, which was good and bad, Good because it fit in my car and on my small table saw, Bad because i didn't get to use my cut sheet which would have made all the cutting much easier if i could have started with 25" wide sheets not 24"

4pi cut sheet"

index.php?t=getfile&id=1764&private=0


3 pi Subwoofer cut sheet:

index.php?t=getfile&id=1765&private=0


Finished all the major cuts for L C R and 2 flanking subs.

index.php?t=getfile&id=1763&private=0


Panels with bracing, The bracing is glued and pined down using an 18gaugae pin gun with 1 1/4" pins. I used this same method to put together the ports, I'll be gluing and clamping everything together from this point.

index.php?t=getfile&id=1761&private=0


needed to finish 3 4pi's and 2 3pi subwoofers.

Here's a dry fit with all the side bracing in place, will had cross support above the woofer when its all together.

index.php?t=getfile&id=1762&private=0


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Just Loaded in 4 Pis
Next Topic: Implementation
Goto Forum:
  


Current Time: Fri Nov 29 16:39:56 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest