AudioRoundTable.com: Pi Speakers » Starting New Build, a Few Questions...

Home » Sponsored » Pi Speakers » Starting New Build, a Few Questions...

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Starting New Build, a Few Questions... [message #81236 is a reply to message #81235]

Fri, 24 April 2015 11:08

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

The volume displaced by the H290C when mounted in the cabinet is approximately 65 cubic inches.

The crossover has no plate-through holes because I wanted one side to be perfectly flat so it could sit on a gasket and mount directly to the cabinet. Mount the components on the solder side and fasten the coils with a silicon adhesive. It acts as both a mount and a cushion for them. Mount the capacitors and resistors so that they sit a little bit above the board, supported by their leads.

Report message to a moderator

[Message index]

		Starting New Build, a Few Questions... By: Jeff V. on Thu, 23 April 2015 20:45
		Re: Starting New Build, a Few Questions... By: Wayne Parham on Fri, 24 April 2015 11:08
		Re: Starting New Build, a Few Questions... By: Jeff V. on Fri, 24 April 2015 20:15

Previous Topic:	4pi Cabinet Port Tuning
Next Topic:	B&C DE250

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 19:29:40 CST 2024