AudioRoundTable.com: Pi Speakers » Another pi midhorn question.

Home » Sponsored » Pi Speakers » Another pi midhorn question.

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Another pi midhorn question. [message #80125 is a reply to message #46840]

Sat, 21 June 2014 13:45

Nelson Bass
Messages: 39
Registered: November 2012

Baron

I made a 3D model of the midrange horn in SolidWorks:

I settled the angles at 90x40deg and the horn mouth width to 24".
That makes the mouth around 11.65" high not 12" and the inside depth is 9.75".

Good enough? Razz

Attachment: 7Pi_Midrange_Horn.png
(Size: 36.90KB, Downloaded 5597 times)

Report message to a moderator

[Message index]

		Another pi midhorn question. By: Kim Schultz on Sat, 07 May 2005 02:56
		Re: Another pi midhorn question. By: Wayne Parham on Sat, 07 May 2005 03:41
		Re: Another pi midhorn question. By: Kim Schultz on Sat, 07 May 2005 04:46
		Re: Another pi midhorn question. By: Wayne Parham on Sat, 07 May 2005 12:52
		Think I got it now :) By: Kim Schultz on Sat, 07 May 2005 15:42
		Re: Think I got it now :) By: Wayne Parham on Sat, 07 May 2005 16:00
		Re: Another pi midhorn question. By: Nelson Bass on Sat, 21 June 2014 13:45
		Re: Another pi midhorn question. By: Wayne Parham on Tue, 24 June 2014 11:04
		Re: Another pi midhorn question. By: GarMan on Mon, 09 May 2005 08:29
		Re: Another pi midhorn question. By: Wayne Parham on Mon, 09 May 2005 15:54
		Re: Another pi midhorn question. By: Kim Schultz on Fri, 13 May 2005 03:22

Previous Topic:	7Pi placement in my room
Next Topic:	Pink Noise Vs. sweeps for measurements

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jul 14 01:24:57 CDT 2024