Home » Sponsored » Pi Speakers » Crossover networks - Inductor mounting (Crossover networks)
Crossover networks - Inductor mounting [message #79962] Fri, 16 May 2014 06:19
gstarey66 is currently offline  gstarey66
Messages: 12
Registered: January 2014
Location: Engineer
Chancellor
Hello all,

Below is a nice presentation on how inductors interact and how to avoid that.

Personally I use a large piece of pegboard to mount the crossover parts to with lots of "free" air between the components to avoid interaction. Pegboard is cheap and the holes are great for mounting parts and putting wires thru.

Anyway, good info on something you should be aware of if building a crossover network. See what you think.

http://www.troelsgravesen.dk/coils.htm

Regards,
Greg
Previous Topic: One Pi & Two Pi tower speaker plans
Next Topic: New member and fanatic of JBL
Goto Forum:
  


Current Time: Tue Nov 05 05:17:41 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest