| 2226H suspension stiffness [message #78561] |
Fri, 06 December 2013 16:33  |
Scholl
Messages: 67
Registered: May 2009
|
Viscount |
|
|
Hi guys,
I just got a pair of used 2226H woofers in and find the suspension tighter then I remember. I know the Vas is on the low side but is the suspension stiffer?
Thanks,
Scott
|
|
|
|
|
|
|
|
|
|
| Re: 2226H suspension stiffness [message #78737 is a reply to message #78572] |
Sun, 22 December 2013 08:32  |
thatsnasty
Messages: 12
Registered: June 2012
Location: Niagara Falls
|
Chancellor |
|
|
| Scholl wrote on Sat, 07 December 2013 07:13 | Do you know how to tell a recone from original? Is the white serial\part number and black dustcap glue an original?
|
Like Wayne said, the easiest way is measurements (comparing a known legit cone to a recone under the same conditions), but from what I've seen, here's a few tips, if you still need em..
Color: Cones should be grey on top, and have "bumps" on the backside, as well as an orange-ish ring around the edges of the back of the cone
Tinsel leads: Where the wires are punched through the cone by the dustcap on the front, both holes should be punched symmetrical to eachother, and have a bit of distance between the dustcap. This means they shouldn't be too close / touching the dustcap.
Markings : As far as I can tell, all my original cones have almost no markings on them. They are basically entirely grey, with bumps on them. The only markings I see are on the frames, and they are stamped.
|
|
|
|
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
