Home » Sponsored » Pi Speakers » Quick question about midhorn kit assembly
Re: Quick question about midhorn kit assembly [message #77592 is a reply to message #77588] Fri, 23 August 2013 21:19 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18787
Registered: January 2001
Illuminati (33rd Degree)

You're exactly right and the gasket is available in case you are going to push your speakers hard, which protects the cone from hitting the plate at very high excursion. It doesn't add much front chamber volume so there is little penalty installing it, but then again, the driver excursion is not excessive so there isn't much gained installing it either. But if you're ever going to go over 100 watts, I'd suggest that you install them.

 
Read Message icon5.gif
Read Message
Read Message
Previous Topic: Nuthin' To Watch On TV?
Next Topic: Reckhorn S-1 electronic crossover???
Goto Forum:
  


Current Time: Sun Nov 24 04:32:39 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest