Home » Sponsored » Pi Speakers » 4Pi crossover study
Re: 4Pi crossover study [message #77226 is a reply to message #77204] Sat, 20 July 2013 18:11 Go to previous messageGo to previous message
Joe Sever is currently offline  Joe Sever
Messages: 11
Registered: May 2009
Chancellor
The plot thickens...

This time I measured with the speaker on its back, and the mic directly over the Radian's diaphragm about 19" away.

I took two measurements: one through the unmodified crossover, and the other directly from the amp to the speaker. The measurements were the same!

index.php?t=getfile&id=1214&private=0

So either I've miswired the crossover, or my measurement setup is faulty. Unfortunately I don't have any other speaker available for reference, otherwise I'd measure it.

Though I suspect the measurements themselves at this point, here's the crossover for scrutiny:

index.php?t=getfile&id=1215&private=0

index.php?t=getfile&id=1216&private=0
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Two way build with Definimax 4012HO and DE250
Next Topic: Compression Drivers
Goto Forum:
  


Current Time: Thu Nov 21 17:58:58 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest