Home » Sponsored » Pi Speakers » 4pi's on the way!
Re: 4pi's on the way! [message #76918 is a reply to message #76912] Sun, 02 June 2013 20:59 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18773
Registered: January 2001
Illuminati (33rd Degree)

Yes, Scott wrote to me asking if the front/back brace needed to be connected to the side/side brace. I replied essentially the same thing I wrote in my last post, that they could be separated a little bit, provided there was no interference with the woofer or tweeter and the sheet of insulation spanning the cross-section could be easily installed and supported by the brace.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Coax in horn
Next Topic: compare 3pi vs Klipsch Synergy F2
Goto Forum:
  


Current Time: Thu Oct 03 01:25:30 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest