Re: 4PI Cabinet plans / question [message #73082 is a reply to message #73069] |
Thu, 21 June 2012 13:34 |
thatsnasty
Messages: 12 Registered: June 2012 Location: Niagara Falls
|
Chancellor |
|
|
Wayne Parham wrote on Thu, 21 June 2012 09:32 | I've sent plans to your email address.
Kits include the binding post terminal, but crossovers by themselves do not. The one we ship in the kits need a 2-1/8" x 2-7/8" hole cutout.
The four π speaker and its crossover are specifically designed for the JBL 2226H. You'll want to buy our H290C waveguide, because the crossover was designed for that as well.
For a center channel, you can simply omit the port, if you wish. I would leave the left and right mains vented, as designed. Also use flanking subs to smooth room modes and the self-interference anomalies from floor bounce and the reflection off the wall behind the speakers.
|
Thanks for the quick response!
Sealed center seems like a good idea then. It will keep the speakers looking "even" as opposed to offsetting the port either way in the center.
I asked about the terminals because it'll likely cost more for shipping 3 terminals to Canada from PE then it would to get them when I buy the x-overs. Is it possible that I can buy 3 from you, without the kit, and get them shipped with the x/o?
Thanks again, if anything else comes up that the search function cannot find, I'll be sure to bug you
|
|
|