AudioRoundTable.com: Pi Speakers » Large Rubber "O" Ring with JBL 2226H

Home » Sponsored » Pi Speakers » Large Rubber "O" Ring with JBL 2226H

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Large Rubber "O" Ring with JBL 2226H [message #72262 is a reply to message #72260]

Thu, 19 April 2012 19:01

dutchswan0311
Messages: 102
Registered: June 2011
Location: Iowa

Viscount

Good. I purchased 1/16" thick sheet of cork material that I then cut to size. I think it will work well. I also purchased #10-32 hex head cap screws to replace the Phillips. I am pretty sure this is what you use as well. I also thought that "O" ring appeared to cause more problems than it fixed. I will use the cork for the woofer as well.

My only remaining issue now is fringe to figure out how to fasten the 15" Dayton Grills to the JBL woofer. :-/

Report message to a moderator

[Message index]

		Large Rubber "O" Ring with JBL 2226H By: dutchswan0311 on Thu, 19 April 2012 16:11
		Re: Large Rubber "O" Ring with JBL 2226H By: Wayne Parham on Thu, 19 April 2012 18:19
		Re: Large Rubber "O" Ring with JBL 2226H By: dutchswan0311 on Thu, 19 April 2012 19:01
		Re: Large Rubber "O" Ring with JBL 2226H By: JCDC on Thu, 19 April 2012 20:41
		Re: Large Rubber "O" Ring with JBL 2226H By: dutchswan0311 on Thu, 19 April 2012 21:19
		Re: Large Rubber "O" Ring with JBL 2226H By: Bill Epstein on Fri, 20 April 2012 18:13

Previous Topic:	My Three Pi Speakers Finished
Next Topic:	Grills for Eminence woofers, sound implications

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Nov 26 21:44:23 CST 2024