Home » Sponsored » Pi Speakers » skywave's 3Pi subwoofer build (skywave's 3Pi subwoofer build)
Re: skywave's 3Pi subwoofer build [message #71633 is a reply to message #71632] Thu, 01 March 2012 22:58 Go to previous messageGo to previous message
skywave-rider is currently offline  skywave-rider
Messages: 104
Registered: May 2009
Viscount
I see, spacers for the flanges on the grill clamps?
These?
http://www.parts-express.com/pe/pshowdetl.cfm?AID=10500969&PID=1941119&Partnumber=260-352&scqty=1
or maybe these:
http://www.parts-express.com/pe/pshowdetl.cfm?AID=10500969&PID=1941119&Partnumber=260-340&scqty=1

To raise them high enough to work ... I think I get it. The cut sheet I downloaded from Eminence shows a thick gasket on top of the woofer frame. But I can't see if there's also one below. Anyway, I will know in a few days.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Alternate idea for 7Pi midhorn enclosure?
Next Topic: Information about the 3 Pi Subwoofer
Goto Forum:
  


Current Time: Wed Dec 18 01:00:47 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest