Home » Audio » General » A speaker/earbud setup in a GPS
Re: A speaker/earbud setup in a GPS [message #71490 is a reply to message #71472] Thu, 23 February 2012 13:10 Go to previous messageGo to previous message
FloydV is currently offline  FloydV
Messages: 124
Registered: November 2011
Location: Boise, ID
Master
This is definitely a solid state amp, and a cheap one though the GPS if far from cheap. Both the earbuds and the speaker are about 8 ohms, it's just that an earbud is so close to your ear drum, the same sound seems 5 times louder.

Not being a tube amp, I think I will chance it. I don't hear any distortion in either mode.

Most new GPS units have blue tooth. A BT headset would never fit under the full face race helmet I wear. Good helmets have to be snug. I can't even pull my helmet over my hearing aids without dislodging them (the bulk fits over the ear).


He who joyfully marches to music rank and file, has already earned my contempt. -- Albert Einstein
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Kids & Music Lessons
Next Topic: Sounds of Everyday Objects
Goto Forum:
  


Current Time: Fri Nov 29 18:10:27 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest