AudioRoundTable.com: Pi Speakers » crossover board assembly

Home » Sponsored » Pi Speakers » crossover board assembly

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

crossover board assembly [message #69234]

Mon, 29 August 2011 17:20

dprice
Messages: 10
Registered: November 2009
Location: Florida

Chancellor

Is there any trick to using the crossover PCBs? Do I just trim the leads to length and tack in place with solder? Or do I need to drill little holes to pass the leads through?

A close-up photo of one done right would be appreciated.

Report message to a moderator

[Message index]

		crossover board assembly By: dprice on Mon, 29 August 2011 17:20
		Re: crossover board assembly By: Wayne Parham on Mon, 29 August 2011 18:02
		Re: crossover board assembly By: dprice on Mon, 29 August 2011 19:03
		Re: crossover board assembly By: Maxjr on Tue, 30 August 2011 14:39
		Re: crossover board assembly By: Wayne Parham on Tue, 30 August 2011 16:03

Previous Topic:	4 pi, oh my!
Next Topic:	Damping material placement

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Oct 14 22:16:33 CDT 2024