Home » Audio » Speaker » Have a pair of Full range drivers - what to(should) do with it?
Have a pair of Full range drivers - what to(should) do with it? [message #67498] Sun, 08 May 2011 14:13 Go to next message
Eldragon65 is currently offline  Eldragon65
Messages: 4
Registered: May 2011
Esquire

What's your thought on enclosure type, also should I ad the tweeter and what type of x-over, or should I utilize 'full range?'

Prefer 1-2 cubic/ft sealed enclosure. Thanks!!! (blue line on chart)

index.php?t=getfile&id=381&private=0


BETSY -K:
Re 5.7 ohms
Fs 49.959Hz
Sd 22.966
BL 5.471
Qms 2.798
Qes .548
Qts .458
Spl 94.6
Vas 82.914L
Mms 9.167g
Re: Have a pair of Full range drivers - what to(should) do with it? [message #67499 is a reply to message #67498] Sun, 08 May 2011 16:44 Go to previous messageGo to next message
Bob Brines is currently offline  Bob Brines
Messages: 186
Registered: May 2009
Location: Hot Springs Village, AR
Master
I can't make out the notes on your attachment. Could you give a brief description of you two different cabinets?

Bob
Re: Have a pair of Full range drivers - what to(should) do with it? [message #67500 is a reply to message #67499] Sun, 08 May 2011 19:44 Go to previous messageGo to next message
Eldragon65 is currently offline  Eldragon65
Messages: 4
Registered: May 2011
Esquire

here is the site with all the info:

http://www.wildburroaudio.com/speakers.php
Re: Have a pair of Full range drivers - what to(should) do with it? [message #67501 is a reply to message #67500] Sun, 08 May 2011 21:38 Go to previous messageGo to next message
Bob Brines is currently offline  Bob Brines
Messages: 186
Registered: May 2009
Location: Hot Springs Village, AR
Master
OK. I'm with the program.

You have the Betsy-K. (You did actually buy a pair, didn't you?) You have no options. You will have to use a sealed box. It is remotely possible that it will go into a BR, but it will be huge. Again, you might fit it into a BiB.

The graphs you are looking at were most likely made on an OB. The clue is that the higher Q Betsy goes lower in the bass than the lower Q Betsy-K. This is why you would choose a high Q driver for an OB application. Actually, everything you need to know is on that product page.

Bob
Re: Have a pair of Full range drivers - what to(should) do with it? [message #67503 is a reply to message #67501] Sun, 08 May 2011 23:51 Go to previous messageGo to next message
Eldragon65 is currently offline  Eldragon65
Messages: 4
Registered: May 2011
Esquire

Thanks!
Re: Have a pair of Full range drivers - what to(should) do with it? [message #67549 is a reply to message #67501] Wed, 11 May 2011 09:42 Go to previous message
Eldragon65 is currently offline  Eldragon65
Messages: 4
Registered: May 2011
Esquire

"You did actually buy a pair, didn't you?"


Unfortunately yes


Previous Topic: Sub woofer Assist
Next Topic: Good wire article
Goto Forum:
  


Current Time: Tue Nov 05 04:58:56 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest