rohitdev Messages: 8 Registered: February 2011 Location: Oregon Ohio
Esquire
Hello All,
My understanding is that I need at least 2 subs to augment my mains (4 pis). Is it necessary that they are identical subs? Can I build one sub and use my existing 10" subwoofer and tweak phase/output by ear?
Also my tube amp has no preouts at all. So would it be ok to send signals to both subs from the same speaker taps that power my 4pis?
Wayne Parham Messages: 18751 Registered: January 2001
Illuminati (33rd Degree)
You can use different subs. I wouldn't try and tap into the speaker outputs though. Instead, tap the line level going into your amp, and run it through a preamp that has two outputs. use this first preamp as the volume control, since you'll want to be able to adjust volume for both the mains and the subs with a single control.
rohitdev Messages: 8 Registered: February 2011 Location: Oregon Ohio
Esquire
Thanks Wayne. What if both the subwoofers accept high level-ins? Will this case be ok? I mean high level out from my integrated to both subwoofers' high level ins?
Wayne Parham Messages: 18751 Registered: January 2001
Illuminati (33rd Degree)
I suppose it will work. Hard to say what quality you'll get. I never cared much for tapping the speaker lines as an input to other devices. But if it's not too much trouble to try, it can't hurt to check it out. If it hums or doesn't sound good, you can always go a different route.