AudioRoundTable.com: Pi Speakers » 2226j (16 ohm) usable?

Home » Sponsored » Pi Speakers » 2226j (16 ohm) usable? (question about 4pi)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 2226j (16 ohm) usable? [message #66545 is a reply to message #66532]

Sun, 06 March 2011 22:06

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

A person could do a 2.5-way to good effect. Just low-pass the lower woofer at 200Hz or so. That wouldn't take much redesign because the top (mid)woofer and tweeter crossover and physical relationship can (and should) remain the same. But a person would still need to analyze standing waves inside the cabinet and go through a test/measurement cycle to dial it in and make sure everything comes together.

Report message to a moderator

[Message index]

		2226j (16 ohm) usable? By: vectordirector on Sun, 27 February 2011 17:30
		Re: 2226j (16 ohm) usable? By: Wayne Parham on Sun, 27 February 2011 21:35
		Re: 2226j (16 ohm) usable? By: vectordirector on Sun, 27 February 2011 22:33
		Re: 2226j (16 ohm) usable? By: Wayne Parham on Sun, 27 February 2011 23:46
		Re: 2226j (16 ohm) usable? By: vectordirector on Mon, 28 February 2011 00:14
		three π / four π By: Wayne Parham on Mon, 28 February 2011 10:08
		Re: 2226j (16 ohm) usable? How about this approach, Wayne? By: ohiogaucho on Mon, 28 February 2011 13:27
		Re: 2226j (16 ohm) usable? How about this approach, Wayne? By: Wayne Parham on Tue, 01 March 2011 08:07
		Re: 2226j (16 ohm) usable? By: Bill Epstein on Sun, 06 March 2011 08:31
		Re: 2226j (16 ohm) usable? By: Adveser on Sun, 06 March 2011 13:21
		Re: 2226j (16 ohm) usable? By: Wayne Parham on Sun, 06 March 2011 22:06

Previous Topic:	Tweeter Change (again !)
Next Topic:	Four Pi R3 Mounting

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 03:04:13 CST 2024