AudioRoundTable.com: Pi Speakers » 2226j (16 ohm) usable?

Home » Sponsored » Pi Speakers » 2226j (16 ohm) usable? (question about 4pi)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 2226j (16 ohm) usable? [message #66532 is a reply to message #66369]

Sun, 06 March 2011 13:21

Adveser
Messages: 434
Registered: July 2009
Location: USA

Illuminati (1st Degree)

If I may say so Wayne...

If you can get the drivers cheap, why not just install two drivers in parallel? Or would this cause too many problems with the design of the speaker box?

While we are on the subject, does more drivers reduce the modes inside the box ala, multisub?

I looked around last night to see if there was an electrical solution and essentially there is no way to dissipate the heat with resistors and it's flat resistance to all frequencies makes them useless.

http://adveser.webs.com/

Report message to a moderator

[Message index]

		2226j (16 ohm) usable? By: vectordirector on Sun, 27 February 2011 17:30
		Re: 2226j (16 ohm) usable? By: Wayne Parham on Sun, 27 February 2011 21:35
		Re: 2226j (16 ohm) usable? By: vectordirector on Sun, 27 February 2011 22:33
		Re: 2226j (16 ohm) usable? By: Wayne Parham on Sun, 27 February 2011 23:46
		Re: 2226j (16 ohm) usable? By: vectordirector on Mon, 28 February 2011 00:14
		three π / four π By: Wayne Parham on Mon, 28 February 2011 10:08
		Re: 2226j (16 ohm) usable? How about this approach, Wayne? By: ohiogaucho on Mon, 28 February 2011 13:27
		Re: 2226j (16 ohm) usable? How about this approach, Wayne? By: Wayne Parham on Tue, 01 March 2011 08:07
		Re: 2226j (16 ohm) usable? By: Bill Epstein on Sun, 06 March 2011 08:31
		Re: 2226j (16 ohm) usable? By: Adveser on Sun, 06 March 2011 13:21
		Re: 2226j (16 ohm) usable? By: Wayne Parham on Sun, 06 March 2011 22:06

Previous Topic:	Tweeter Change (again !)
Next Topic:	Four Pi R3 Mounting

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 03:07:38 CST 2024