AudioRoundTable.com: Pi Speakers » insulation for the 2pi tower

Home » Sponsored » Pi Speakers » insulation for the 2pi tower

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

insulation for the 2pi tower [message #62703]

Sat, 15 May 2010 14:06

fuj32
Messages: 5
Registered: May 2010
Location: saint louis mo

Esquire

Questions about what type of insulation and where it goes.

1.) i know its suppose to be R13, but is it Fiberglass?

2.)Also, Faced or Unfaced?

3.)And how do you attach it? (glue, staples etc?)

4.)For installing it, the plans suggest along one side, the top, and the front baffle up to the woofer. Is this all that is needed?

ALSO for the bracing, i saw that one guys (Shane) pictures show a 3rd brace near the top, just a few inches down from the top.

Is that nessassary??

And one last question...When i make the braces, does the square frame NEED to have the "sticks" in the middle making four little squares? Make sense?

THANKS in advance

Report message to a moderator

Re: insulation for the 2pi tower [message #62707 is a reply to message #62703]

Sat, 15 May 2010 18:14

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

I personally like R13 (fiberglass) insulation. I hate putting it in, as I'm always scratchy for the rest of the day. But it does exactly what I want it to do. I buy it in rolls, cut it to size, remove the vapor barrier and glue it in with white glue. I used to staple it in, but after many years I've stopped that because staples can sometimes vibrate loose and come out.

You should line the front, side and top and also span the cross section by laying a sheet on each set of braces, spanning the cross-section. Your braces can be a simple cross-brace, a window brace or a combination of both techniques.

Report message to a moderator

Re: insulation for the 2pi tower [message #62709 is a reply to message #62703]

Sat, 15 May 2010 18:31

fuj32
Messages: 5
Registered: May 2010
Location: saint louis mo

Esquire

ok sounds good. So only 2 braces is nessassary correct?

i just want to make sure i do everything as close to perfect as i can.

Report message to a moderator

Re: insulation for the 2pi tower [message #62710 is a reply to message #62709]

Sat, 15 May 2010 20:50

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

That's right. Do a cross-brace 1/3rd up from the bottom and another 1/3rd down from the top. Use 1x2 wood stock or scrap of approximately the same dimensions, and make them snug, but not too tight. Just snug enough that light tapping is all it takes to put them in place.

Report message to a moderator

Previous Topic:	Pi kits?
Next Topic:	12PI plan or CAD ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 25 17:58:05 CST 2024