AudioRoundTable.com: Pi Speakers » 6Pi - 7Pi bass cab same dimensions?

Home » Sponsored » Pi Speakers » 6Pi - 7Pi bass cab same dimensions?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Close, but not the same [message #53275 is a reply to message #53272]

Sun, 01 March 2009 22:10

Psychoacoustic
Messages: 75
Registered: May 2009

Viscount

Wayne, thanks again for the response and plans. Getting closer to the build... couple more questions.

I understand that this has been done to death, but one more time please...
In Japan, I can only source 10mm ply. The plans call for 20mm (3/4").
For the Pi7 specifically, would gluing two 10mm ply sheets together or one 10mm ply and one 10mm MDF be better, or no difference?

Recently, there was some discussion of crossover value changes. Do you have these updated, populated crossovers ready to go?

PaulW, who has built the Pi7, mentioned enlarging the mid-horn flare dimensions. Any thoughts on this?
Thanks again.

Report message to a moderator

[Message index]

		6Pi - 7Pi bass cab same dimensions? By: Psychoacoustic on Sun, 01 March 2009 19:33
		Close, but not the same By: Wayne Parham on Sun, 01 March 2009 20:56
		Re: Close, but not the same By: Psychoacoustic on Sun, 01 March 2009 22:10
		Re: Close, but not the same By: Wayne Parham on Mon, 02 March 2009 00:18
		Oh, my mid-horn mkII idea By: PaulW on Mon, 02 March 2009 17:05
		Re: Oh, my mid-horn mkII idea By: Wayne Parham on Mon, 02 March 2009 17:12
		Re: Oh, my mid-horn mkII idea By: PaulW on Mon, 02 March 2009 17:27
		You may now graduate to finger-painting By: Psychoacoustic on Mon, 02 March 2009 18:07
		Re: You may now graduate to finger-painting By: PaulW on Tue, 03 March 2009 05:00
		Front edge trim on midhorn By: Wayne Parham on Mon, 02 March 2009 21:27
		Re: Close, but not the same By: Psychoacoustic on Wed, 04 March 2009 21:14
		Re: Close, but not the same By: Wayne Parham on Wed, 04 March 2009 21:42

Previous Topic:	7pi XO points
Next Topic:	plans for Pi 4

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 09:08:26 CST 2024