Has anybody mixed pi's with Klipsch surrounds?

Any other suggestions (1pi, 2pi, anything else)?

Could you email me the plans?

If I maintain the correct box volume and port spec's, could I make them shallower and possibly angle them down a bit from the corner where the ceiling and wall meet? I would also maintain the same baffle width if necessary. This is for a work-in-progress dedicated theater and I would prefer to have them blend in a bit.

Thanks,
Max

You have a little more wiggle room on more traditional two-way speakers with first-order crossovers like the one π and two π models. Keep the box volume and tuning frequency the same and you can expect bass performance to be pretty much the same. Don't make one dimension significantly longer than the others though, at least not without further analysis. This can introduce pipe modes that should be considered and possibly mitigated.

Another thing, even though baffle position isn't as critical as the larger models, I'd still maintain the same woofer/tweeter physical relationship as shown in the plans. Keep the tweeter close to the woofer, and on the same plane vertically (one on top of the other) or very close to it. You can offset both drivers to one side or another if you wish, but don't offset the tweeter centerline with respect to the woofer centerline. I've done some speakers that way, but never more than 1/4λ at the crossover point. I prefer the vertical nulls to be above and below the speaker, not offset to the sides.

I will maintain the baffle layout, volume, port specs, but make it fit my room a bit better. We'll see what I come up with.