AudioRoundTable.com: Pi Speakers » 2 Pi Tower Pics

Home » Sponsored » Pi Speakers » 2 Pi Tower Pics - Any Problem With My Design?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

18mm Baltic Birch [message #53020 is a reply to message #53019]

Sun, 28 December 2008 22:08

breakfastchef
Messages: 28
Registered: May 2009

Chancellor

Went with the 'highly recommended' 18mm thick baltic birch plywood. Rather expensive but significantly fewer void than any sheet good at a Lowes or Home Depot. Also, many, many more plys, too. I do not think what I got was cabinet grade, but it worked just fine. At some time in the future I may veneer the whole thing.

Report message to a moderator

[Message index]

		2 Pi Tower Pics - Any Problem With My Design? By: breakfastchef on Wed, 24 December 2008 21:00
		Re: 2 Pi Tower Pics - Any Problem With My Design? By: breakfastchef on Wed, 24 December 2008 21:01
		Re: 2 Pi Tower Pics - Any Problem With My Design? By: Wayne Parham on Wed, 24 December 2008 23:43
		My 2 Pi Towers Were Born Today By: breakfastchef on Thu, 25 December 2008 22:01
		Re: My 2 Pi Towers Were Born Today By: Wayne Parham on Fri, 26 December 2008 11:40
		Re: My 2 Pi Towers Were Born Today By: Matts on Fri, 26 December 2008 14:29
		Re: My 2 Pi Towers Were Born Today By: breakfastchef on Fri, 26 December 2008 15:03
		Re: 2 Pi Tower Pics - Any Problem With My Design? By: Wayne-o on Sun, 28 December 2008 19:29
		18mm Baltic Birch By: breakfastchef on Sun, 28 December 2008 22:08

Previous Topic:	JBL 2446 & 2226 in a Corner Horn Design
Next Topic:	Efficiency Spes for the 2 Pi Tower

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 25 10:07:30 CST 2024