AudioRoundTable.com: Pi Speakers » 4 Pi baffle cutout question

Home » Sponsored » Pi Speakers » 4 Pi baffle cutout question

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

4 Pi baffle cutout question [message #52979]

Wed, 17 December 2008 14:13

GarlandGarland
Messages: 60
Registered: May 2009

Viscount

I noticed on the Eminence website where they specify a cut out dimension for the H290 horn of 10.3 inches by 4.9 inches, Yet, the 4 Pi baffle cut out document calls for 9.5 inches by 4.75 inches. Is there an error somewhere? Like maybe in my reading!

Thanks.
G.

Report message to a moderator

Re: 4 Pi baffle cutout question [message #52980 is a reply to message #52979]

Wed, 17 December 2008 14:48

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

The lip on those H290's is so thin, you want as much meat as possible, especially if you route them flush. In fact, we put a half baffle behind the sections that are routed. Anyway, my point is I like to make that cutout as small as possible, which is why the plans show a slightly smaller cutout area.

Report message to a moderator

Re: 4 Pi baffle cutout question [message #52981 is a reply to message #52979]

Wed, 17 December 2008 15:01

Matts_
Messages: 17
Registered: May 2009

Chancellor

I've used Wayne's dimensions- works fine. I just put the horn lips on the outside and haven't routed or inset it. Plenty of room for t-nuts inside.

Report message to a moderator

Re: 4 Pi baffle cutout question [message #52983 is a reply to message #52981]

Wed, 17 December 2008 16:14

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

The cutout Eminence suggests is too large. We did a few with the Eminence suggested hole size way back when, and it barely left enough edge to put mounting holes through. So I measured the horn and came up with dimensions that would allow flush fit but still had a maximum size lip. It's 9-1/2" x 4-3/4". Eminence should probably update their spec sheet to use this figure, because 10.3 x 4.9 is neither convenient nor useful. It's too big.

Report message to a moderator