AudioRoundTable.com: Pi Speakers » Hey Bill !!! plywood question

Home » Sponsored » Pi Speakers » Hey Bill !!! plywood question

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Hey Bill !!! plywood question [message #52867 is a reply to message #52845]

Fri, 14 November 2008 15:39

breakfastchef
Messages: 28
Registered: May 2009

Chancellor

I looked around my local Home Depot and spotted some decent looking plywoods. Upon curosry inspection, the surfaces looked very clear and I did not see any voids around the perimeter. AS I recall, the 3/4" stock was five or six plys. Would one of these also be a good choice for speaker cabinets, or should I continue to seek out Baltic Birch from a specialty supplier?

3/4" x 4' x 8' Baltic Plywood - $49.88/sheet
3/4" x 4' x 8' Sanded Plywood (one surface only) - $43.88/sheet

Report message to a moderator

[Message index]

		Hey Bill !!! plywood question By: Wayne-o on Sat, 08 November 2008 13:07
		Use Baltic Birch By: Wayne Parham on Sat, 08 November 2008 22:47
		Re: Use Baltic Birch By: Wayne-o on Sun, 09 November 2008 11:26
		Re: Use Baltic Birch By: Wayne Parham on Sun, 09 November 2008 20:59
		Re: Use Baltic Birch By: Bill Epstein on Mon, 10 November 2008 07:25
		Re: Use Baltic Birch By: Wayne-o on Mon, 10 November 2008 12:00
		Re: Use Baltic Birch By: beto on Fri, 21 November 2008 21:50
		Re: Hey Bill !!! plywood question By: breakfastchef on Fri, 14 November 2008 15:39
		Re: Hey Bill !!! plywood question By: Matts on Fri, 14 November 2008 20:33
		Re: Hey Bill !!! plywood question By: Wayne Parham on Sat, 15 November 2008 01:04
		Re: Yup! By: Bill Epstein on Sat, 15 November 2008 12:00
		Re: Yup! By: Wayne Parham on Sat, 15 November 2008 15:54

Previous Topic:	theater 4 plans please
Next Topic:	New 4 Pi questions

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Sep 13 07:22:47 CDT 2024