AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » High Efficiency

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: I will have to find the values for the amp and pre... [message #52684 is a reply to message #52682]

Sun, 28 September 2008 11:59

Matts
Messages: 359
Registered: May 2009

Grand Master

I looked on the Canary Audio page, and the 300B push/pull amps have an input sensitivity of only 0.72 volts to reach full volume. Looks like the pre-amps have 9dB gain. So...there's the problem. Post your hometown and see if someone has some nice Bottlehead or other diy gear with some good Pi 4's you can listen to... You might make a transition many of us have already made!

Report message to a moderator

[Message index]

		High Efficiency By: pretzel_logic on Sat, 27 September 2008 10:04
		Re: High Efficiency By: Matts on Sat, 27 September 2008 19:17
		Re: High Efficiency By: Bill Epstein on Sat, 27 September 2008 20:35
		I will have to find the values for the amp and pre... By: pretzel_logic on Sun, 28 September 2008 07:35
		Re: I will have to find the values for the amp and pre... By: Matts on Sun, 28 September 2008 11:59
		Re: I will have to find the values for the amp and pre... By: pretzel_logic on Sun, 28 September 2008 14:05
		Re:Out in the sticks? By: Bill Epstein on Sun, 28 September 2008 21:08
		I'm further South By: pretzel_logic on Tue, 30 September 2008 20:06
		Re: I'm further South By: Matts on Wed, 01 October 2008 02:57
		Re: I'm further South By: pretzel_logic on Wed, 01 October 2008 20:13
		Re: I will have to find the values for the amp and pre... By: Matts on Mon, 29 September 2008 01:04
		Re: One solution By: Bill Epstein on Tue, 30 September 2008 21:59
		Re: One solution By: pretzel_logic on Thu, 02 October 2008 20:25

Previous Topic:	Another important Pi tweak
Next Topic:	Two Pi

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 13:13:14 CST 2024