AudioRoundTable.com: Pi Speakers » HF bypass cap for active crossovers/EQ

Home » Sponsored » Pi Speakers » HF bypass cap for active crossovers/EQ

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

HF bypass cap for active crossovers/EQ [message #52541]

Tue, 26 August 2008 23:05

Chris R.
Messages: 82
Registered: May 2009

Viscount

Wayne,
For active crossovers and EQ, does it make sense to set the graphic EQ such that there is 6dB boost at 20KHz relative to 10KHz?
That would at least match the slope of your passive crossover component. I'll have to check that against what I have set up already.
Is 10KHz where the bypass cap kicks in?
Thx, Chris

Report message to a moderator

Tweeter horn compensation [message #52542 is a reply to message #52541]

Tue, 26 August 2008 23:49

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

The response graph you want for the tweeter circuit looks like the chart shown below. It is the conjugate of the HF driver's power response.

Report message to a moderator

Re: Tweeter horn compensation [message #52545 is a reply to message #52542]

Wed, 27 August 2008 12:47

Chris R.
Messages: 82
Registered: May 2009

Viscount

Hi Wayne,
So I got the slope right, but starting point off an octave. So, that's 12dB of delta. Seems like a lot, but it does seem to
sound right. The end goal is to get a flat measured acoustic response, right?
Thx, (wish I could be done tweaking, but not in my nature) Chris

Report message to a moderator