| 7 Pi bass cabinet [message #52167] |
Sun, 25 May 2008 22:36  |
PaulW
Messages: 71
Registered: May 2009
Location: UK
|
Viscount |
|
|
|
Hi Wayne, I'm just cutting out the sections for my bass cabinets and thinking about changing the style of the rear section - the 'pointy' bit. To soften their looks a bit I was wondering if I could radius the angles instead of having them sharp? This would also mean the rear panels on the apex couldn't run the full width (12 3/8") but would be reduced to about 7" in the middle of the angled part. Would there be any sonic changes in having a wide gap at the apex (rear where it faces the wall) of the cabinet and not having the panels going fully to the outer edges? I hope that makes some sense? Paul W
|
|
|
|
|
|
| Re: 7 Pi bass cabinet [message #52169 is a reply to message #52168] |
Tue, 27 May 2008 05:39  |
PaulW
Messages: 71
Registered: May 2009
Location: UK
|
Viscount |
|
|
|
I think you answered the question really, but I'll do a quick sketch later and post it for you comments anyway. Thanks. Paul
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Will do...... [message #52188 is a reply to message #52187] |
Sun, 08 June 2008 19:06 |
PaulW
Messages: 71
Registered: May 2009
Location: UK
|
Viscount |
|
|
|
Although the next post should be a picture of them up and running, only a few little bits and pieces to do now. 1st set of 7 Pi's in the UK? Paul
|
|
|
|
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
