AudioRoundTable.com: Pi Speakers » anyone tried B&C compression drivers?

Home » Sponsored » Pi Speakers » anyone tried B&C compression drivers?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: anyone tried B&C compression drivers? [message #51150 is a reply to message #51149]

Tue, 29 May 2007 16:31

dB
Messages: 234
Registered: May 2009

Master

The B&C is 7.8Ohm / Eminence is 6.x Ohm. It gives more 0.5dB in aimspice. If there is a problem in the sound output (with it being to high) a 1.0 Ohm resistor in series (1+5.5 Ohm) would be fine (if there is the need). I am not sure the R1 resistor is 5.5 Ohm.

Report message to a moderator

[Message index]

		anyone tried B&C compression drivers? By: Matts on Tue, 29 May 2007 09:14
		Re: anyone tried B&C compression drivers? By: Cuppa Joe on Tue, 29 May 2007 10:51
		Re: anyone tried B&C compression drivers? By: Cuppa Joe on Wed, 30 May 2007 08:27
		Re: anyone tried B&C compression drivers? By: Wayne Parham on Tue, 29 May 2007 15:48
		Re: anyone tried B&C compression drivers? By: dB on Tue, 29 May 2007 16:31
		Re: anyone tried B&C compression drivers? By: Wayne Parham on Wed, 30 May 2007 15:14
		Re: thanks.... By: Matts on Wed, 30 May 2007 10:32
		Re: thanks.... By: dB on Wed, 30 May 2007 18:11

Previous Topic:	2Pi tower upgrade
Next Topic:	High Efficiency 15" Woofer Suggestions For 9 Cu Ft Ported Box ??

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 23 18:36:20 CST 2024