I'm looking forward to getting my own set of sevens done - the first steps are to build a jig to miter the corner joints. I'm planning to use MDF with routed locking joints for the corners...we'll see how well it works. The special bit is on its way from Rockler along with a big bottle of glue and a pile of veneer.

This will also be my first application of the Eurekazone cutting system - apart from a couple of training test cuts, so I'm looking forward to seeing how it all works in reality after lots of planning.

Have you by any chance a cutting plan for the cabinets? I have worked one out which should be fine, but if you have one I'd like to see it.

Regards,
tim