AudioRoundTable.com: Pi Speakers » tools for building my own xovers

Home » Sponsored » Pi Speakers » tools for building my own xovers

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

tools for building my own xovers [message #50544]

Tue, 16 January 2007 22:38

freo
Messages: 9
Registered: May 2009

Esquire

Hello from Australia
I am interested in building speakers from scratch, I have built the ed frias diy kit and I am now waiting for my pi 2 tower kit to arrive. I have some drivers I have pulled from old speakers, a couple of oval kef base drivers I think they are b139's, and a couple of good quality tweeters I was going to buy some mid range drivers and try my luck. I was wondering what equiptment I would need to build and measure the crossovers. Any help would be appreciated
Regards Roger

Report message to a moderator

Re: tools for building my own xovers [message #50545 is a reply to message #50544]

Wed, 17 January 2007 09:01

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

You can start off with circuit modeling tools like Spice and crossover simulators like the one in LSPCad. For acoustic measurememts, you might use a PC-based system like Speaker Workshop.

Report message to a moderator

Re: tools for building my own xovers [message #50551 is a reply to message #50544]

Thu, 18 January 2007 05:06

Kim Schultz
Messages: 85
Registered: May 2009

Viscount

I use JBL Speakershop for designing boxes and crossovers, then measure with DLSA Pro, and tune the design by hand and ear.

The beauty about DLSA Pro is that it can measure TS specs too, and it is not too expensive.

regards
Kim

Report message to a moderator

Re: tools for building my own xovers [message #50552 is a reply to message #50544]

Thu, 18 January 2007 06:34

dB
Messages: 234
Registered: May 2009

Master

Hello roger friend,
I use a "cheap" €52,00 Inductance Capacitance Meter by RANGE (RE6000) to measure coils and caps.
You will spend a lot of money in xovers, sometimes more than in speakers to get it right. Thats why some factories sometimes don't mess with that, or the speaker(s) goes over (many)$1.000,00 USD. Be careful. After all it's our pleasure not theirs.
dB, I am from Portugal.

Report message to a moderator