Home » Sponsored » Pi Speakers » 8 Pi Question ?
8 Pi Question ? [message #50282] Tue, 21 November 2006 09:27 Go to next message
j.luis cruz . is currently offline  j.luis cruz .
Messages: 154
Registered: May 2009
Master
Hy again Wayne . Im considering to make only 1 round port ( I sum the three rectangular areas of the front ports ) and calculated a round port of 4 5/8 in the back of the 8 pi cabinet .my question is what if i throw the port into the corner of the room near a few inches could have a gain instead of the three front ports firing into the open room . thanks

Re: 8 Pi Question ? [message #50286 is a reply to message #50282] Tue, 21 November 2006 11:24 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18791
Registered: January 2001
Illuminati (33rd Degree)

You can make the port in a different shape, and positon doesn't matter as long as it doesn't cause standing wave pipe behavior.

Corner loading works at bass frequencies several feet away from the apex, so a port on the front of a corner-loaded speaker will act the same as one on the back unless the speaker is several feet deep.

When a sound source is placed at the apex of a trihedral corner, it radiates purely into eighth-space. The walls of the corner define the radiating angle. In this situation, the walls don't act as reflectors because a wavefront travels along them or away from them rather than towards them and reflected by them.

When a sound source is near a boundary, then it confines the radiating area and also acts as a reflector. At low frequencies, where the distance to the boundary is less than 1/4λ, the boundary constrains the radiating angle without any anomalies in frequency response. Above 1/4λ distance, the boundary begins to act as a reflector and peaks and dips will occur at 1/4λ multiples.

The end result of all this is that woofers and ports can be placed fairly far away from corners and still radiate into eighth-space.


Re: 8 Pi Question ? [message #50299 is a reply to message #50286] Wed, 22 November 2006 15:10 Go to previous messageGo to next message
j.luis cruz . is currently offline  j.luis cruz .
Messages: 154
Registered: May 2009
Master
Hy What cause standing waves pipe behaivor Wayne ?

Re: 8 Pi Question ? [message #50311 is a reply to message #50299] Fri, 24 November 2006 16:58 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18791
Registered: January 2001
Illuminati (33rd Degree)

Standing waves are what give a pipe organ its sound. The length of each pipe tunes its frequency. This is also the principle at work in transmission lines.

Previous Topic: What do you make of this "white paper"?
Next Topic: 7pi mid-horn
Goto Forum:
  


Current Time: Fri Nov 29 22:07:39 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest