Hi ... What are the negative points for using a bigger driver on a horn that was originally designed for 8" driver? Horn is from JBL SR4735X. http://www.jblproservice.com/pdf/SR-X%20Series/SR4735X.pdf Throat is 19 sq. in. Normal Sd/St was 2.43. I would like to use a 10" driver, but Sd/St would be 3.5. BTW will use open chambered. Thanks, Zene
Wayne Parham Messages: 18786 Registered: January 2001
Illuminati (33rd Degree)
Model it using Hornresp. You can probably find a driver that will work for you. Just by looking at it, I think a JBL 2012 or Eminence Delta 10 would probably sound good on that horn. Might be worth a try.
Saved my bacon again. Speaker I was thinking about had xMax of 1mm. Now I realize that could be awful without back chamber. Will get very friendly with HornRes. Footnote ... My reconer says the Eminence vc lead outs are breaking too often. He's quit recommending them for band use. May or may not be a concern for home. Thanks, Zene
Wayne Parham Messages: 18786 Registered: January 2001
Illuminati (33rd Degree)
Eminence's pressed-frame drivers have spade lugs on cardboard mounting tabs. That's pretty common for inexpensive speakers, and I agree, you don't want to put any pressure on them. I give them some support underneath with my finger when pressing on the connector 'cause they'll break if unsupported.
Eminence's cast-frame drivers use much more durable connectors.
Wayne ... It's not the terminals it's the leads that connect direcly to the vc. Explaination was they don't have strain relief so they vibrate until they break. Eminence is aware of problem so is not minor. Can send you one if it's of any importance. Might not be if you've had no problems. Zene
Wayne Parham Messages: 18786 Registered: January 2001
Illuminati (33rd Degree)
I'm not aware of that problem and I've done some pretty intense tests of Eminence drivers. Like most other speakers, the leads from terminals to cone are looped to allow for excursion. What driver have you encountered this kind of failure from?
Wayne Parham Messages: 18786 Registered: January 2001
Illuminati (33rd Degree)
Jerry McNutt at Eminence says there have been no unusual problems related to connectors or leads breaking in any of their drivers. This just hasn't been a problem for them.
Wayne Parham Messages: 18786 Registered: January 2001
Illuminati (33rd Degree)
I've had my share of problems with Eminence drivers over the years, but connection wires haven't been an issue. It's more likely that something else is going on.
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
