AudioRoundTable.com: Pi Speakers » Question for FredT re: One-Pi Towers

Home » Sponsored » Pi Speakers » Question for FredT re: One-Pi Towers

Mon, 17 July 2006 08:51

GarMan
Messages: 960
Registered: May 2009

Illuminati (2nd Degree)

1 cu ft? I thought the standard one-pi was 0.70 cu ft. How did you end up with an oversized PI?

		Question for FredT re: One-Pi Towers By: GarMan on Wed, 12 July 2006 14:50
		Re: Question for FredT re: One-Pi Towers By: FredT on Thu, 13 July 2006 19:11
		Correction By: FredT on Fri, 14 July 2006 03:25
		Re: Question for FredT re: One-Pi Towers By: GarMan on Fri, 14 July 2006 07:29
		Re: Question for FredT re: One-Pi Towers By: FredT on Fri, 14 July 2006 14:18
		Re: Question for FredT re: One-Pi Towers By: j.luis cruz . on Fri, 14 July 2006 09:59
		Re: Question for FredT re: One-Pi Towers By: FredT on Fri, 14 July 2006 14:15
		Also By: FredT on Fri, 14 July 2006 14:26
		Re: Also By: j.luis cruz . on Fri, 14 July 2006 18:45
		Hey, Wayne By: FredT on Fri, 14 July 2006 14:20
		Re: Hey, Wayne By: Wayne Parham on Sat, 15 July 2006 17:41
		Re: Hey, Wayne By: FredT on Sat, 15 July 2006 19:25
		Re: Hey, Wayne By: Wayne Parham on Sat, 15 July 2006 22:51
		One Cubic Feet? By: GarMan on Mon, 17 July 2006 08:51
		Re: One Cubic Feet? By: Wayne Parham on Mon, 17 July 2006 12:42

Previous Topic:	Are notches required on 12pi?
Next Topic:	Hl10c Heatsink data

Goto Forum:

] [

]

Current Time: Tue Nov 26 10:32:31 CST 2024