AudioRoundTable.com: Pi Speakers » Power Transfer into Professional Pi7

Home » Sponsored » Pi Speakers » Power Transfer into Professional Pi7

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Power Transfer into Professional Pi7 [message #49540]

Mon, 29 May 2006 07:21

Tobias
Messages: 19
Registered: May 2009

Chancellor

I currently have the Pi7s with all JBL drivers, and driving them with a tube amp that is hard wired for 4 ohms. I've contacted the manufacture and indicated that the speakers I'm driving should have a relatively flat impedance of 8 ohms. The manufacturer can change the output to 8 ohms, however they claim their amp has been optimized to use the 4 ohm tap. Whether I keep my current amp or change to a tube amp with multiple taps, is there any benefit to using 8 ohm taps vs 4 ohm taps with the Pi7s?

Report message to a moderator

[Message index]

		Power Transfer into Professional Pi7 By: Tobias on Mon, 29 May 2006 07:21
		Re: Power Transfer into Professional Pi7 By: Wayne Parham on Mon, 29 May 2006 11:17
		Re: Power Transfer into Professional Pi7 By: Tobias on Mon, 29 May 2006 11:42
		Re: Power Transfer into Professional Pi7 By: j.luis cruz . on Mon, 29 May 2006 17:47
		Re: Power Transfer into Professional Pi7 By: Tobias on Mon, 29 May 2006 18:19
		Re: Power Transfer into Professional Pi7 By: Russellc on Tue, 30 May 2006 20:42
		Re: Power Transfer into Professional Pi7 By: Tobias on Wed, 31 May 2006 04:51
		Re: Power Transfer into Professional Pi7 By: Manualblock on Wed, 31 May 2006 15:06
		Re: Power Transfer into Professional Pi7 By: TomM on Sat, 17 June 2006 15:25

Previous Topic:	Pi's for the Dynaco ST-70
Next Topic:	Pi7 can I do it DIY?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Nov 26 17:37:27 CST 2024