AudioRoundTable.com: Pi Speakers » Anybody with plans and circuit for 12" based 3 ways?

Home » Sponsored » Pi Speakers » Anybody with plans and circuit for 12" based 3 ways?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Anybody with plans and circuit for 12" based 3 ways? [message #48621]

Sun, 15 January 2006 13:58

braddog100
Messages: 11
Registered: May 2009

Chancellor

I have some 12" Cerwin Vegas'. I know they are not the best, but I would like to put them to use. I also have a pair of Axon T1S Shielded Dome tweeters. Zn ~ 8ohm; 2000 - 20,000; Pn ~ 50W;
Lm ~ 90 db; Re 6,4ohm; fs ~ 1550 Hz;
b ~ 1.7mm; Sd ~ 6.7 cm2;

I would like suggestions for some quality mids to go with this.
I have seen some 4ohm setups for reasons unkown to me, But I would prefere 8ohm since I use alot of tube gear. I could bi-amp since I have a good solid state unit. Would be open to several opinions.

Looking for Box design, circuit, mid range suggestions. I could also concider other tweeters.

I thank you very much,

Brad

Report message to a moderator

Re: Anybody with plans and circuit for 12" based 3 ways? [message #48624 is a reply to message #48621]

Sun, 15 January 2006 20:48

Wayne Parham
Messages: 18786
Registered: January 2001

Illuminati (33rd Degree)

Sorry, but you'll need a lot more information to make a good loudspeaker design. I might humbly suggest that the amount of time required to obtain the information you'll need to do a good job would probably be more than the drivers are worth. Then again, the learning experience is worth a lot, so it might be interesting for you on that level. But if you're looking for a good quality build without a lot of enfgineering, you might want to build from plans that have already been designed and tested.

Report message to a moderator