Home » Sponsored » Pi Speakers » Request for wooden HF horn plans
Re: What High Frequency Horns? Where? [message #48159 is a reply to message #48147] Fri, 11 November 2005 19:40 Go to previous messageGo to previous message
Bill Martinelli is currently offline  Bill Martinelli
Messages: 677
Registered: May 2009
Illuminati (1st Degree)
I dont remember plans like that. You did some work in horn response that gave the best angle for the conical throat since I wanted to make a seperate aluminum throat piece. Not only dont I remember plans for any type of horn like that. The horns I've been making have curves sides. not flat. and the top and bottom are not curves but a straight +10 degree in proportion to the flair rate. Good luck with your new horns. The cnc stuff sounds cool.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: MA Audiophile Get Together
Next Topic: Request for 2 pi tower speaker plans
Goto Forum:
  


Current Time: Thu Nov 28 17:09:36 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest