Home » Sponsored » Pi Speakers » flush mount or not?
Re: reinforcement.... [message #47277 is a reply to message #47276] Thu, 07 July 2005 11:39 Go to previous messageGo to previous message
Matts is currently offline  Matts
Messages: 359
Registered: May 2009
Grand Master
a good thing about this type of reinforcement, assuming you just put another layer of wood on the inside around the hole, is t-bolts will hold it in place rather than fighting it. So it should be easy to do- a little glue to start out with and get the hole right, then the t-bolts to hold the speaker on. Will look very nice.

What amps are you using these with?

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Near Field or Mid Field Moniters
Next Topic: studio one
Goto Forum:
  


Current Time: Mon Nov 25 11:32:18 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest