AudioRoundTable.com: Pi Speakers » Mounting H290 flare ( with driver attached) to front baffle.

Home » Sponsored » Pi Speakers » Mounting H290 flare ( with driver attached) to front baffle.

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Mounting H290 flare ( with driver attached) to front baffle. [message #45856 is a reply to message #45850]

Mon, 22 November 2004 20:54

Bill Martinelli
Messages: 677
Registered: May 2009

Illuminati (1st Degree)

Your going to love these when you get them fired up. For mounting the H-290 horn. Like the guy's say, T-nuts are very helpful especially in MDF. Make your Baffle cut out for the horn
4.750 tall by 9.625 wide.
The horn will fit perfectly and just tip the driver slightly to get it in the opening.

Bill

Report message to a moderator

[Message index]

		Mounting H290 flare ( with driver attached) to front baffle. By: Frank Mena on Mon, 22 November 2004 09:56
		Re: Mounting H290 flare ( with driver attached) to front baffle. By: Wayne Parham on Mon, 22 November 2004 10:24
		Re: Mounting H290 flare ( with driver attached) to front baffle. By: GarMan on Mon, 22 November 2004 11:08
		Re: Mounting H290 flare ( with driver attached) to front baffle. By: Bill Martinelli on Mon, 22 November 2004 20:54

Previous Topic:	Hi wayne any new development on the 12 pi sub horn?
Next Topic:	Thermo Pi 3 as kit ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 18 02:17:26 CST 2024