AudioRoundTable.com: Pi Speakers » The eternal quesiton: Tube friendly or not

Home » Sponsored » Pi Speakers » The eternal quesiton: Tube friendly or not

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

The eternal quesiton: Tube friendly or not [message #45146]

Mon, 02 August 2004 06:19

roland
Messages: 46
Registered: May 2009

Baron

Hi,

Having read all I can find on tube friendly, damping factor etc, I have the following questions:

If a tube amp has sufficiently low out put impedance (and the resulting high damping factor), I could still be all right with just a couple of watts? It seems that the low damping factor in SETs is the real problem and not necessarily the low power output? After all, if the speaker has 100db/1w/m, 2-4 Watts should be enough, yes?

In for example a PSE arrangement where the additional tube is used for lowering output impedance instead of doubling the power could do the trick??? Example: using 2 x 6as7 (one tube envelope) with for arguments sake a 5kohm primary would yield high enough damping factor to allow for higher Zmax on the woofer...????

Sorry if the quesiton is foolish, but I am really curious on this:)

Roland

Report message to a moderator

Re: The eternal quesiton: Tube friendly or not [message #45147 is a reply to message #45146]

Mon, 02 August 2004 07:39

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

That's right, Roland. If the amplifier's damping factor is high, i.e. output impedance is low, then speaker impedance fluxuations won't affect response so much.

Report message to a moderator

thanks. I like no nonsense answers. (nt) [message #45148 is a reply to message #45147]

Mon, 02 August 2004 08:36

roland
Messages: 46
Registered: May 2009

Baron

Report message to a moderator

Re: thanks. I like no nonsense answers. (nt) [message #45149 is a reply to message #45148]

Mon, 02 August 2004 09:10

Yury
Messages: 52
Registered: May 2009
Location: Kiev, Ukraine

Baron

hello Roland!
you wrote:
1. "If a tube amp has sufficiently low out put impedance "
if!!!! it's not always. it's depend of scheme, solution. we have to reach it first. the same as transistor amplifier.
2. "and not necessarily the low power output" - it's depend of drivers sound pressure. if you'll load any amp to driver 0.08 Pa - high damping factor of your amplifier don't take a big sound. but 0.4 Pa driver be able to makes biiiigggg loud! :) by 1W
a propos, what do we mean about 1W to 4 ohm? U^2/R. ok. U=2V. nice. signal swing have to be about 5V by oscillograph, couse it's mean square value.
sorry my English.