Should I put anything else between the 2002 and H290? I noticed one of my horns does not lay perfectly flat, although it could cinch up when I bolt it on.
Also this is odd but my H290s look different from the back and one is a black satin and the other is a flat black....they clearly came off different molds. I ordered another ...hopfully there is not a third mold!! ha ha!
The 2 X 1/4-20 should be sufficient to mount the driver to horn. Quarter inch diametre bolt with 20 count thread. You're looking at a pretty short bolt, either half inch or 3/4". But there're only a dime each at Home Depot bulk bins, so you can probably afford both. Get some locking washers too.
Wayne Parham Messages: 18835 Registered: January 2001
Illuminati (33rd Degree)
6mm x 18-22mm would work, yes. But the fastener head is close to the horn bell and harder to work with. Most complain about the near proximity when using these mounting holes.
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
