AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » 2pi Tower Plans

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

2pi Tower Plans [message #43633]

Mon, 12 January 2004 22:41

Duncan McBride
Messages: 41
Registered: May 2009

Baron

The internet is a wonderful thing. I found pictures of garman (A) 's 2pi tower under construction http://f1.pg.photos.yahoo.com/ph/lowgc/album?.dir=/Pi+Towers&.src=ph&store=&prodid=&.done=http%3a//f1.pg.photos.yahoo.com/lowgc
and learned that butt joints were just fine from Louis Lung and that medium density fibreboard is the medium of choice. http://www.lungster.com/l/speakers/mdffaq/mdf.html

The kit is on the way and I already have the big pieces cut out. This is a lot of fun. I found the mdf at Home Depot in 3/4", so I added 1/8" all around to keep the interior dimensions the same. I'll use the port size for the 3/4" material specified in the plans. Now all I have to do is decide on an amplifier and preamp....

Report message to a moderator

Re: 2pi Tower Plans [message #43638 is a reply to message #43633]

Tue, 13 January 2004 09:10

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

Sounds great - You're well on your way. Please keep us posted on your progress!

The series of posts that Gar did was very good, wasn't it? It would be helpful to pull them all together with references in a single post; Maybe I'll do that sometime soon.

Report message to a moderator

Previous Topic:	Do I "need" a subwoofer?
Next Topic:	Modeling stage 7 pi

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 01 01:33:40 CST 2024