Home » Sponsored » Pi Speakers » T/S Measurements
Re: T/S Measurements [message #43175 is a reply to message #43171] Sun, 23 November 2003 13:17 Go to previous messageGo to previous message
Manualblock is currently offline  Manualblock
Messages: 4973
Registered: May 2009
Illuminati (13th Degree)
Wayne; Thanks Much for the prompt reply and I will tell you why I asked and keep it brief. After completing my pi 4's about 4 weeks ago(I built them exactly to your specs) I have been listening and I have slowly grown to enjoy them beyond my expectations. Musicality, lively, tone etc. Now I would like to build my altec valencia components into a pi configured box. On the altec site they seem to think all the woofers should be measured before designing the bass bin claiming that altec data is unreliable. Since this project will be expensive I am posting this under this thread hoping that some might have either experience or opinion concerning designing around the published specs or paying for testing. I have my pi sticker on the 4's but is it apropriate to use if the altec drivers are used?( I bought the 4's from you).
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: electrovoice 30w in pi corner horn?
Next Topic: 4pi as a wedge monitor
Goto Forum:
  


Current Time: Wed Dec 04 20:48:06 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest