Home » Sponsored » Pi Speakers » Great Plains Audio Club Meeting
Re: Great Plains Audio Club Meeting [message #42394 is a reply to message #42391] Mon, 08 September 2003 12:47 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18738
Registered: January 2001
Illuminati (33rd Degree)

We did hook up your Decware amp to the two π's. Maybe you were busy with the brisket while we were listening, but the first thing we did was to connect the π's up to your amp. Only after that did we hook up the Paramours. Both amps sounded very good, with the differences being mainly that the Paramours were louder. They may have made a little more bass, but it was difficult to tell because it was louder. We could change the volume on your Decware amp but not on the Paramours until we wired in Mark's preamp. Another thing I noticed was that your Decware Select doesn't hum as much. The Paramours make a little bit of hum but your Decware amp was dead quiet.

At any rate, if you didn't get a good listen we'll definitely need to hook 'em up again for you.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: tiniest Pi speaker
Next Topic: Flush mounting and diffraction
Goto Forum:
  


Current Time: Sun Aug 04 07:44:05 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest