Home » Sponsored » Pi Speakers » Tweakin' Two's
Tweakin' Two's [message #42143] Fri, 08 August 2003 19:41 Go to previous message
Jerrod Harden is currently offline  Jerrod Harden
Messages: 38
Registered: May 2009
Baron
Hi Guys!

Works been very slow so I've had some time to play with the 2's a little. I wanted to work on the big speakers, but can't until works better. Then I have no time to play! Anyway, I had various materials around the house and decided to put them to use. I started with a roll of plenum rated cat 5 network cable I had. That became braided speaker cable. I ran a run directly to the tweeter and terminated the amp end. I then braided up a nifty little harness that runs from the tweeter to woofer with a break in the positve side to wire in the inductor. The negative side runs continuous without any break in the wire. While I had all the drivers out I decided to damp the exponential horn with mortite. I probably tripled the mass of these lightweights. I decided to carry on that same agenda and damped the Alpha baskets with some dynamat I'd had in the parts box for ten years. To be honest I've never been a big tweaker. Well, I should rephrase... I've tweaked but rarely heard a lot of difference. This time I do. The speakers are noticeably different. Cleaner and more defined comes to mind. Different instruments seem to really stand apart more where they used to be glossed over just a bit. The high frequencies sound much cleaner and more extended. The low frequencies even appear to have a more controlled sound with greater pitch definition and a more taut sound. It's a bit hard to explain the difference but I think you get the idea. For the record I replaced some AR flat 16 gauge cable that I had biwired with. Obviously I changed to many things at once to tell exactely what contributed to the change in sound. I think the damping of the horn was a good move and I feel the single run of cable could have contributed to the increased coherency perhaps more so than the particular materials or geometry of the cable itself. And I suppose that damping the speaker basket could have reduced some resonance in the driver. Or maybe I just wanted them to sound better so they do. :) Whatever it is I don't have that same desire to try a different tweeter anymore. Now I'm just enjoying music! Have fun!
Jerrod

 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Crossover help
Next Topic: Push Pull Subwoofers
Goto Forum:
  


Current Time: Fri Nov 29 10:42:43 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest