Horn Pictures! [message #42028] |
Sat, 26 July 2003 02:02 ![Go to next message Go to next message](/forum/theme/AudioRoundTable/images/down.png) |
Adrian Mack
Messages: 568 Registered: May 2009
|
Illuminati (1st Degree) |
|
|
Hey all, I've finished construction of my horns, I'll share a few pics for ya, its not painted yet though but who cares I'll do that later :-) Its a 300Hz flare freq and is used from 440Hz and up to 1.6KHz. Its got the Eminence Alpha 6 driver on it.
|
|
|
VERY nice! [message #42029 is a reply to message #42028] |
Sat, 26 July 2003 02:11 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) ![Go to next message Go to next message](/forum/theme/AudioRoundTable/images/down.png) |
toxicport.e
Messages: 48 Registered: May 2009
|
Baron |
|
|
GREAT HORNS! il have to make some,someday! , money permitting. about the 21inch,im going to model it,not that its very practicable or cheap :-D my 2226 wil do i think :^)
|
|
|
Great stuff!... [message #42030 is a reply to message #42028] |
Sat, 26 July 2003 05:38 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) ![Go to next message Go to next message](/forum/theme/AudioRoundTable/images/down.png) |
ToFo
Messages: 219 Registered: May 2009
|
Master |
|
|
...and thanks for the follow up on Eighteen Sound. I have been wanting to do a mid horn for a long time. A cross between radial and constant directivity, like a giant Peavey CH-3 would be my goal. This inspiration might just push me over the egde. Cool! Enjoy 'em, Thomas
|
|
|
|
Re: Sweet! [message #42035 is a reply to message #42033] |
Sat, 26 July 2003 15:23 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) |
Adrian Mack
Messages: 568 Registered: May 2009
|
Illuminati (1st Degree) |
|
|
Hey Wayne,I did do my modeling in Hornresp. I changed the design a bit though, and made it smaller than before (the horn flare is only 12" long at the moment), so that way I would use it a bit higher up, and also it would better fit in a tower case now, seeing its not very deep. Also I found the air trapped in the front of the cone is the perfect front chamber, and no rear chamber is required if I wish to extend HF response further, but sacrifice some of the low end, which is OK, I'll just cross them a bit higher (440Hz). To my thinking this should also decrease throat distortion, as its being used further away from both horn cutoff and driver resonance. I'll do a FR plot today hopefully then I'll post it here :-0 Also harmonic distortion tests if I get speakerworkshop set up! Adrian
|
|
|