AudioRoundTable.com: Pi Speakers » Choose a match loudspeaker and x-over question.

Home » Sponsored » Pi Speakers » Choose a match loudspeaker and x-over question.

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

System possibilities [message #41982 is a reply to message #41980]

Sun, 20 July 2003 19:12

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

You can use an attenuator to bring down an efficient subsystem to match other less-efficient subsystems. This is a solution that will work with a single amplifier. But it obviously means that overall system sensitivity is set to that of the lowest rated component.

If you choose to bi-amp or tri-amp, you can use more gain and power for a subsystem that is less efficient instead of attenuating. But this requires multiple amplifiers and more hardware.

Report message to a moderator

[Message index]

		Choose a match loudspeaker and x-over question. By: Gabriel on Sun, 20 July 2003 11:12
		Crossovers, damping and matching subsystems. By: Wayne Parham on Sun, 20 July 2003 12:29
		Thank's Mr. Wayne, but need some more explanation. By: Gabriel on Sun, 20 July 2003 18:32
		System possibilities By: Wayne Parham on Sun, 20 July 2003 19:12
		Thank's again. By: Gabriel on Sun, 20 July 2003 20:21

Previous Topic:	This is what happens when you put 2 Delta Pro's, etc,etc...
Next Topic:	high effeciency 8"

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 23 15:46:08 CST 2024