Re: Theater 4 Pi Driver Screws [message #41926 is a reply to message #41925] |
Tue, 15 July 2003 04:51 |
Larry Acklin
Messages: 54 Registered: May 2009
|
Baron |
|
|
I use 1/4 inch hex head bolts with t-nuts. I mix some jb-weld and use it to seat the t-nut, and to "seal" around the outside of the t-nut flange. I draw the t-nut in using a bolt and washer (no hammering). This works well for me on the PA cabinets. I mount the driver with the 1/4 inch bolts and a washer under the head. Larry Acklin
|
|
|